MASSIVE 10% SILVER-PLATED CONDUCTORS

Massive conductors prevent mutual interference between the wires in twisted cables and reduce jitter. Massive silver-plated conductors are perfect for high-frequency applications. These signals, due to their high frequency, primarily travel on the surface of the conductor. Because this surface is made of a highly pure grade of silver, the performance is nearly equivalent to that of a solid silver conductor, but the pricing is much closer to that of solid copper cables. This is an incredibly cost-effective way to produce high-quality Digital Coax cables.

DIELECTRIC BIAS SYSTEM WITH RADIOFREQUENCY TRAP

All insulation between two or more conductors is also a dielectric whose properties affect the integrity of the signal. When the dielectric has no bias, dielectric involvement (absorption and non-linear release of energy) causes different amounts of time delay (phase shift) for different frequencies and energy levels, which is a serious problem for highly time-sensitive audio with multiple octaves. The inclusion of an RF Trap (developed for AudioQuest's Niagara series power products) ensures that radiofrequency noise is not induced into the signal conductors of the DBS field elements.

CARBON-BASED 6-LAYER NOISE-DISSIPATION SYSTEM (NDS)

Shielding the shielding reduces contamination of the ground potential by RFI.

SILVER-PLATED BRAIDED SHIELDFOAMED-POLYETHYLENE INSULATION

Any solid material next to a conductor actually becomes part of an imperfect circuit. Wire insulation and printed circuit board materials all absorb energy. Some of this energy is stored and then released as distortion. Because air absorbs virtually no energy and polyethylene has low loss and a good distortion profile, Foamed-PE with its high air content causes much less of the out-of-focus effect that occurs with other materials.

COLD-WELDED HANGING-SILVER OVER PURE RED COPPER SYSTEM

This plug design allows for a completely heat-free connection between the cable and the plug. The connection between the plug and the conductor is made using the AQ cold-weld system, which creates an optimal connection that fully preserves the integrity of the conductor. The cold-weld system refers to a combination of high pressure on the contact point combined with a silver or copper-infused paste. (For the silver conductors of Boxer, we use a silver paste).